Fiat 500 Replacement Key Fob
It could be time to replace the battery if your 500 remote key fob isn't working. If you replace the battery but it's still not working, the problem may be elsewhere.
At United Locksmith, we specialize in the creation of new keys for classic cars. We have the tools and components required for this service.
Dead Coin Battery
A dead battery is the main cause of your Fiat 500 keyfob not locking or unlocking the doors. The battery for the coin cell in the key fob will deplete quickly if you don't use it frequently enough. If your remote is beginning to show signs of a loss of range or stopped working or not responding, then the battery could be dead.
The battery inside the key fob is held in place by steel retaining clips. If the clips aren't tight enough, it can cause problems with contact, which can prevent your remote from receiving power. Make use of a flathead screwdriver to break open the retaining clip and then remove the old battery. Be sure to choose a replacement battery with the same kind of voltage, the same size, and specification as the original battery.
The key fob could also be damaged or corroded through exposure to water. Even a short shower in soapy water can harm the electronic https://www.g28carkeys.co.uk/fiat-car-key-replacements-near-me/ within. Keep your key fob dry.
Water Damage
If your key fob isn't operating properly, it may be caused by water damage. Key fobs have rubber seals that prevent them from being damaged by a light rain or a splash of water. However, it is essential to keep your keys safe from the pool, ocean, and washing machine!
img width="326" src="
">
The key fob is equipped with an electronic chip that transmits a signal to your car's immobilizer system. This is the reason why your 500 can start or lock, however should the chip become wet, it's unable to longer work.
You can try cleaning the inside electronics of your keyfob with isopropyl alcohol or an electronic cleaner to see whether they're still working. It is recommended to replace a key fob if it is submerged in salt water instead of trying to repair it yourself.
A replacement fob could cost you a little bit, but it's a lot cheaper than having to have your Fiat 500 towed to a dealership and repaired there! You can also do it yourself by following just a few steps. Be sure to have the correct type of battery before attempting to open your key fob. There are step-by-step directions for any car keyfob online.
Faulty Chip
The chip in the key fob connects directly with the immobiliser of your car to ensure that the vehicle will start only when the proper keys are inserted. If the chip is damaged or destroyed it won't allow your car to start regardless of what you do.
A chip that is defective can happen due to several reasons, but the most common cause is water damage or an unresponsive battery. It is recommended to leave the repair to a professional locksmith, who will be able to replace the chip quickly and at an affordable cost.
If your key fob fails to function after exposure to clean tap water or rain, remove the battery and clean the electronic component using a paper towel to ensure it is fully dry before putting it back into. If the key fob will not function, there's the possibility that it has a fried component and needs to be replaced.
Many people will seek out their dealer when in need of an entirely new Fiat key fob, however this could be a expensive alternative. If you're seeking a cost-effective solution to have your Fiat key fob repaired Look no further than United Locksmith. We have all the tools and knowledge required to fix your Fiat fob in a professional and timely manner.
Faulty Receiver Module
Fiat key fobs transmit an electrical signal to the vehicle, which will unlock and close doors (and start the car if it has an automatic transmission) up to 50 feet. There are many reasons why a fob could stop working. This includes a dead coin-battery, water damage, worn-out buttons or a receiver issue signal interference, or an issue with the chip.
If the fob was placed in the pocket that has been subject to extreme trauma (such as being dropped on the hard floor or washed in the washing machine) it might not be able to connect with the Body Control Module (BCM) of the vehicle. The BCM is a security system that can only accept signals from genuine keys.
You will need to replace the fob in case this occurs. A professional locksmith can handle the entire key replacement process including programming a new key for your 500. In fact, they could provide you with a replica key that works just like your original fob (and costs less than the price).
![[PukiWiki]](image/pukiwiki.png "[PukiWiki]")
