Reasons Why Your Nissan Qashqai Key Fob Won't Work
The Qashqai's bigger dimensions give it an SUV feel. Its ride on 19-inch alloy wheels in Ti and STL models may also be a bit firm. The front tyres of the Qashqai can lose grip on rough surfaces, and its CVT might occasionally exhibit wrist-flexing torque steer.
It is usually caused by a dead coin battery which is easily replaced in a matter of minutes. Make sure the battery you replace is of the same size, voltage and specifications.
Water Damage
Water damage is one of the most frequent causes for a Nissan keyfob to display the "key ID is incorrect" message. The rubber seals on the key fob protect the chip's electronic circuit, but prolonged exposure to moisture could cause it to stop working correctly. This is usually the case when you drop your key fob in the ocean or into a swimming in a pool, but it can also happen if it gets wet due to rain or soapy hands.
If your key fob was exposed to water over an extended period of time, you may need to clean it using isopropyl and electronic cleaner. It could also require to be sent to a specialist to repair or replace it.
If your key fob require replacement, the procedure is relatively simple. First, ensure you have an appropriate multipack battery (CR2032 3V). Remove the front and back cases using the flat-head screwdriver. You'll need to take out the clips for retaining metal and push out the old battery and replace it with the new one. Reassemble the fob and replace the mechanical key. Check to see if it functions correctly. If it isn't it is necessary to go to your local Nissan dealer or a professional locksmith to replace the chip on the key. The chip is typically not damaged by water so it isn't too costly.
https://www.thekeylab.co.uk/nissan-car-keys/ might not function is that the battery for the coin is dead. These batteries last for three to five years, however they can become faulty over time if the fob has been frequentedly dropped. You can replace the battery, but be sure to use the same voltage and same size as the first. If you use a different battery it may cause the key to have an incorrect key ID which could prevent it from pairing with your vehicle.
The most efficient method to change the battery on the Nissan Qashqai Key Fob is to pry it open with an small screwdriver that has a flat head. The screwdriver should be inserted into a small notch on the bottom of the fob, and twist it gently to split the two halves of the key fob. Then, remove the old CR2025 button cell battery and insert another one after confirming its location on the fob.
img width="431" src="
">
Before putting the new battery in ensure that there is no dirt or water damage to the terminals. If so, clean the terminals using a small amount isopropyl ethanol. You'll also want to make sure the pole cables are connected properly - they must be connected to the positive and negative poles of the battery, respectively.
Fault Diagnosis
If your Nissan Qashqai key fob stops working after exposure to clean rain or tap water it could be an indication of an internal chip issue. Changing the battery won't fix this, and you'll have to buy another key fob. If you dropped the key fob on the ground and it stopped working instantly it's most likely due to the damage to the internal chip. If you clean the chip with isopropyl ethanol and paper towel and then replace it with the key fob, you can usually get it working again.
Key ID Incorrect is a common mistake that you might see on the dashboard of your car. This means that the vehicle is unable to recognize the key fob and not allow it to start the engine. This problem can be caused several ways, such as water damage, issues that are undetectable within the key fob circuitry or RFID interference.
The key fob will stop working if the 12 volt batteries are dead or do not provide enough electrical current. This will affect the remote keyless system as well as central locking on your Nissan Qashqai, as well as making it impossible to start the engine using the key fob (if equipped with Intelligent Key). If you're unable lock or unlock the door manually you must check the batteries in your key fob and make sure they are in good condition. You could also try re-inserting the battery to reset the transmitter.
Reprogramming
If the key fob was not submerged in saltwater the device should be able to be revived by a simple wash of clean water. You can also clean the electronic chip by using isopropyl or electronic cleaner. If none of these work it is possible to replace the key fob.
If your Nissan Intelligent Key is still not working, there could be a problem with the connection between it and the car. To relink it, start by turning the key into the ignition, without turning on the car. Continue this process until you see the danger lights flash twice. Then, turn off the vehicle and take off the key.
Open the fob compartment in your vehicle's fob compartment. It's usually found on a door jamb or the handle of the door for the driver. Find the small button marked "program" and press it. Once the process has been completed you will hear the sound of a chime.
Now that your Intelligent Key is relinked to the car now is the time to try it out. Stand some distance away from the car, and press all the buttons on the key. If the lights flash and the horn squeaks it means the key is successfully linked to the Nissan. You can also test it close to the Nissan.
![[PukiWiki]](image/pukiwiki.png "[PukiWiki]")
