Peugeot 308 Key Fob Replacement
Peugeot's 308 could be catching on a bit but it's still eye-catching. It's not the plushest car in its class - an Ford Focus or Volkswagen Golf will help you stay away from surface imperfections - but it's a relaxed and a civilized driving experience.
We often get asked at Coded Car Keys to replace peugeot key fobs. These tips can help whether the problem is intermittent, or constant.
Water Damage
img width="387" src="
">
If you accidentally drop your key fob into a puddle, or if it gets wet while kayaking canoeing, rafting or canyoning it is likely to be damaged by water. The best way to avoid this from happening is to keep it in a dry bag when you're outdoors or performing activities where the fob could be exposed to a lot of water.
You'll also want to make sure that the fob is dry before opening it up and re-using it. If you notice any smells emanating from the fob (such as industrial liquid or windshield washer fluid) This is a further indication that it's been submerged.
A circuit board that is wet could cause the battery to dump its charge or even explode. If you can remove your keyfob 308 out of the water you need to turn the button side up and shake as much water out as you can before opening the casing. After you open it, take off the battery and wipe the circuit board with an alcohol-soaked cotton swab. 90-percent isopropyl alcohol.
Other reasons that your Peugeot 308 remote entry keyless system might not work could be due to a dead coin-cell battery or receiver module malfunction signal interference or a faulty chip. If none of these are the issue, try resetting your system by disconnecting the battery at 12 volts for around 15 minutes.
Dead Coin Battery
Peugeot cars come with remote start technology that allows drivers to start their car from a distance, allowing them to warm up or cool down the car prior to entering. This feature is extremely beneficial especially during the cold winter months. However, sometimes the remote stop system stops functioning due to a variety of causes, such as a dead coin battery.
A coin-shaped battery in the key fob has a life span of between two and four years, depending on how often it's used and where it is purchased. The date for use-by is typically written on the package or written in the manual.
If the key fob stops working after exposure to water that is clean then you must remove the battery, then clean the electronic chip with a paper towel and isopropyl alcohol, then dry it completely before replacing it. In the event of exposure to soapy or salty water, the chip might be fried and you will require replacing the key fob altogether.
If you're unsure if the battery is defective, you can check its voltage with a multimeter that is connected to both the terminals for plus and minus. The voltage should range from 12 to 13 volts, but if it is lower, the battery needs to be replaced. You can also reset your onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should start after this.
Faulty Receiver Module
If you're not seeing the "Key Detected" message on your dashboard, then it's possible that the receiver module has been afflicted with a fault. It is the part that sends out an alert when the key fob turns on. It also functions as an alarm, and stops the car from starting if it doesn't have the correct key.
The cause could be a number of causes, such as water damage or simply aging. If your Peugeot 308 key fob was exposed to dirty tap water, as in the chip that is located inside is damaged. In this case you will have to remove it and thoroughly clean it with isopropyl or an electronic cleaner. Once it's dry you can put the battery back in and test it again.
If the issue persists, it is a good idea that you visit the local Peugeot expert or locksmith. They can utilize a diagnostic tool in order to pinpoint the problem and fix it.
The loss of your Peugeot car keys could be a stressful experience. However, a reputable auto locksmith can address the issue in only a few minutes. They can program your vehicle and cut a fresh, working key for you. Click here to find a local locksmith near you.
Faulty Electronic Chip
The chip in the Peugeot 308 key fob plays a vital part in the remote control system. If the chip is damaged, you may be unable to start your car or receive a message that says "anti-theft". If this happens, the only way to fix the problem is to obtain a new key. Professional auto locksmiths can provide this service in the shortest time.
The chip in your Peugeot 308's key fob may become faulty for many reasons, such as sweat, water damage, or dirt. If your Peugeot key fob has been exposed soapy or dirty water, it needs to be cleaned as soon as possible. You can make use of a paper towel and isopropyl alcohol to wipe the electronic component. Then, you need to allow the battery to completely dry.
https://www.thekeylab.co.uk/peugeot-car-keys/ can cause the key fob to stop functioning. This can be caused by other devices operating at the same frequency as your Peugeot key fob. It could be caused by unsafe conditions or objects that are within the vicinity of the vehicle. If you experience this issue you should visit the Peugeot dealership.
The Peugeot 207/308 key fob is very delicate and requires special care. It is not recommended to drop it or throw it around. If you lose something, try to find it as soon as possible. You can reset all the on-board computers by disconnecting the 12 volt battery for a short period of time. Remove the negative cable before the positive.
![[PukiWiki]](image/pukiwiki.png "[PukiWiki]")
