Peugeot 308 Key Fob Replacement
Peugeot's 308 might be getting on a bit however, it's still eye-catching. It might not be the most luxurious car in its class and it's a Ford Focus or Volkswagen Golf will help you stay away from surface imperfections - however, it's a comfortable and a civilized drive.
We get asked frequently at Coded Car Keys to replace peugeot key fobs. No matter if the issue is constant or intermittent the following tips will help.
Water Damage
When you accidentally leave your key fob in a puddle or splash it with water while swimming, kayaking, canoeing, rafting or canyoning, it's most likely to suffer water damage. The best way to stop this from happening is to always keep it in a dry bag whenever you're outdoors or performing activities in which the fob may be exposed to excessive amounts of water.
You'll also need to make sure that the fob is completely dry before opening it up and reusing it. If you detect any smells emanating from the fob like an industrial-like liquid smell or windshield washer fluid, this is another sign that it's been submerged in water.
A wet circuit board can cause the battery's charge to drop its charge, or even explode. If you can remove your keyfob 308 out of the water, turn the button side up and shake as much water as you can prior to opening the casing. Once you have opened it, take out the battery and wipe the circuit board using an abrasive soaked in 90-percent isopropyl alcohol.
img width="340" src="
">
Other reasons why your Peugeot 308 remote entry keyless system may not function include a dead battery in the coin-cell or receiver module issue signal interference or a defective chip. If none of these are the issue, try resetting the system by disconnection of the battery with 12 volts for about 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote start system which allows drivers to start their car from the distance, allowing them to warm up or cool down the vehicle before entering. This feature is extremely useful, especially during winter's cold and chilly months. The remote start system can be stopped for a variety of reasons, such as the battery being dead.
The coin-shaped battery within the key fob may last between two and four years, based on how often it is utilized, the place it was purchased, and how it is utilized. The date of use will be printed on the package or marked in the user manual.
If the key fob stops working after being exposed to clean tapwater, remove the battery and clean the electronic chip with the help of a paper towel that has been soaked with isopropyl ethanol. Then dry the chip completely before replacing. If you expose it to salty or soapy water, the chip could be fried and you will require replacing the key fob completely.
If you're not sure whether the battery is defective You can test its voltage with a multimeter attached to both the minus and plus terminals. The voltage should read approximately 12-13 volts but if it is lower, the battery must be replaced. You can also reset your computer in the onboard computer by disconnection and reconnecting the 12 volt batteries in reverse order. ( https://www.thekeylab.co.uk/peugeot-car-keys/ , then negative cable). The engine should start after this.
Faulty Receiver Module
If you're not receiving the "Key Detected" message on your dashboard, then it's possible the receiver module has discovered a problem. It's that part that sends an alarm to the car when your key fob is activated, which acts as an immobiliser and prevents it from starting until the correct key is used.
This can be due to a number of factors, including water damage or just the aging process. If the electronic chip in your Peugeot 308 keyfob is damaged by dirty tap water it could be due to the fact that the keyfob was exposed to it. In this scenario, you'll need to remove it and thoroughly clean it using isopropyl or an electronic cleaner. Once the battery is dry then you can try again.
If the issue persists, it is a good idea that you visit the local Peugeot expert or locksmith. They'll be able to use a diagnostic tool to identify the problem and fix it.
It can be a stressful experience to lose your Peugeot car key. However, a trained auto locksmith can fix the issue in a matter of minutes. They can cut a new key and then program it into your vehicle, ensuring that you're back on the road again as quickly as possible. Click here to find a locksmith near you.
Faulty Electronic Chip
The chip in the Peugeot 308 key fob is a critical part in the remote control system. If the chip is damaged, you may have problems starting your car or receive a message stating "anti-theft". If this occurs, the only option to fix the problem is to purchase a new key. Luckily, professional auto locksmiths can provide the service within the shortest period of time.
The chip in your Peugeot 308's key fob may fail due to many reasons, such as sweat, water damage or dirt. If your Peugeot key fob was exposed to dirty or soapy water, it should be cleaned right away. You can wipe the electronic component with an absorbent paper towel that has been soaked in isopropyl Alcohol. After that, you should allow the battery to dry completely.
Radio interference can cause a key fob's functionality to cease. This could be due to other devices use the same frequency as your Peugeot keyfob. It could also be caused by weather conditions or objects in the vicinity. It is recommended that you visit a Peugeot dealer if you encounter this issue.
The Peugeot Key Fob 207/308 is delicate and requires special attention. It is crucial not to throw or drop the key fob. If you lose something, try to find it as soon as possible. You can reset all the on-board computers by disconnecting the 12 volt battery for a few minutes. Be sure to disconnect the negative first, and then the positive.
![[PukiWiki]](image/pukiwiki.png "[PukiWiki]")
