How to Replace a Nissan Juke Spare Key
Nissan Juke is an attractive and fun hatchback with an unusual engine configuration. It's quite noisy but still a blast to drive.
The key fob battery in the Nissan Juke has to be replaced every two years or so, or if it's low. https://www.thekeylab.co.uk/nissan-car-keys/ to do at home, but you'll require some tools.
Dead Coin Battery
If your Nissan Juke key fob isn't working the first thing you should check is the coin battery inside. It may be dead and require to be replaced, which is a simple fix that takes just a few minutes. You can do this by flipping the fob over and opening the tiny latch and release on the back. Remove the battery that was in use and then replace it with an alternative one, making sure it's facing downwards in the fob. Line between the two halves of the fob with care.
The fob must be cleaned if it was exposed to water before you can insert a new battery. This can be done using a paper towel along with isopropyl alcohol or electronic cleaner, and allow it to dry completely before re-inserting battery.
img width="358" src="
">
To start the car the key fob must also be paired to the car. This can be done by following the instructions in the owner's manual or by using an OBDII scan. If the key fob is not been linked, it is the most likely reason of why it has stopped working. It could also be that the fob is equipped with an issue with the chip, but this is a rare occurrence. In this scenario an entirely new receiver module may be required. If this is the scenario, the module will need to be replaced by an authorized technician.
Water Damage
The key fob is powered by batteries, and the batteries need to be changed every two years or more, or at the first sign of your car not responding when you hit the "start" button. Keys have rubber seals to keep water out, however submerging the key fob into a pool or ocean water could cause damage to the chip inside the. If this is the case you'll have to purchase an alternate key from Nissan or a locksmith.
If the key's chip is an operating chip it's possible that the computer has simply lost connection to it, which can occur for a variety of reasons. A simple restart of your car can fix this, but in the event that the key is showing the "Key ID" error message, you'll need to contact Nissan or an auto locksmith for assistance.
The three most common causes of this problem are dead key fob batteries or keys that are not programmed, and a damaged or defective key fob that has been damaged or broken. The first two problems are fairly easy to fix while the third one is more difficult to identify and repair immediately however, it can be fixed with patience. WhoCanFixMyCar? lets you compare Nissan Key Replacement prices in your local area and schedule your repair. It only takes minutes and you can read reviews from local garages, Nissan car mechanics and dealerships before you decide.
Faulty Chip
The key fob on your Nissan Juke contains a special chip which sends a message to the vehicle when you turn it. If the chip is damaged, it can cause the key to cease working. In this instance it is only possible to repair the issue by replacing the key. There are a variety of reasons your Nissan Juke's key could be defective, such as water damage or a dead battery for your coin, or a broken receiver module.
If your key fob stops working after washing it or bath, you need to check the chip for water damage. Check that the clips holding it are not loose and that the chip is not exposed to any water. If you see any indications of water damage to the electronic component, unplug the battery and wipe it down with isopropyl alcohol or electronic cleaner.
If the chip is faulty You will need to visit the local locksmith or dealership. They will need to know the year as well as the model, make and year of your vehicle to locate an appropriate replacement. You'll also need to write down your VIN (Vehicle ID Number) so the dealer or locksmith can know exactly what key you have. This will enable them to check the correct key code and ensure they are cutting the correct one.
Faulty Receiver Module
The key fob sends a radio frequency signal to your car to perform many functions. The key fob can open your trunk while you hurry with groceries to your car or even start your car by pressing a button on the fob. It can also open your windows and turn the horn on if you accidentally lock the keys inside your car.
If the key fob stops working, it could be an issue with the receiver module inside the vehicle. The receiver modules are tuned to detect specific frequencies that match the signals that are transmitted by the Nissan key fob. If your car has an inoperable receiver module and it stops responding to any signal sent by the key fob.
It is always a good idea to have an extra Nissan key fob in the event that your original key is lost or breaks. A locksmith or a dealership can program a spare key that works with your Nissan. This will allow you to avoid the hassle of losing your keys or locking them inside your car.
If your Nissan Juke's key fob was exposed to rain or clean tap water, you could fix the issue by cleaning it using isopropyl, or an electronic cleaner. If the chip is damaged you will need to purchase a new keyfob that can be coded for your vehicle by a dealer or locksmith.
![[PukiWiki]](image/pukiwiki.png "[PukiWiki]")
