How to Replace a Nissan Juke Spare Key
img width="358" src="
">
Nissan Juke is a fun and stylish hatchback that features an unusual engine configuration. It's quite noisy but it's still a lot of fun to drive.
Replace the battery of the key fob of your Nissan Juke every two years or when it's low. It's simple to do at home, but you'll require some tools.
Dead Coin Battery
If the key fob on your Nissan Juke has stopped functioning, make sure you check the battery in the coin. It may be dead and needs to be replaced. This is a straightforward fix that takes only less than a minute. Flip the fob upside down so that you can access the tiny latch/release on the back. Replace the old battery with the new one, making sure it's facing the bottom of the fob. Make sure to align the two halves with care.
The fob must be cleaned if it has been exposed water before you can install a new battery. Clean the fob with isopropyl or electronic cleaner and a towel. Then, let it dry completely before reinstalling the battery.
The key fob must also to be connected to the car to start it. This can be accomplished by following the instructions in the owners manual or using an OBDII scanner. The most likely reason the key fob stopped working was because it was not linked to the car. It is also possible that the fob has an issue with the chip, but this is rare. In this scenario an entirely new receiver module could be needed. If this is the situation it should be replaced by a skilled technician.
Water Damage
Key fobs are powered by batteries and the batteries should be replaced every two years, or at the point that the vehicle stops responding when you press the "start" switch. The rubber seals on keys keep water out, but submerging the key fob in the pool or ocean water could damage the chip's electronic. If this happens you'll have to purchase the replacement key from Nissan or a locksmith.
It's possible that the computer lost connection to the key fob that could be due to a variety of factors. https://www.thekeylab.co.uk/nissan-car-keys/ of the car will resolve this issue, but should the key be showing the "Key ID" error message, you'll need to contact Nissan or an auto locksmith to get help.
Three common causes are a dead battery for the key fob, a key that is not programmed, or an unrepaired key fob that is damaged. The first two are fairly simple to fix while the third one is more difficult to diagnose and repair immediately however, it can be fixed with patience. WhoCanFixMyCar? lets you compare Nissan Key Replacement costs in your area and schedule your repair. Read reviews about local Nissan dealerships, Nissan mechanics, and garages in just a few moments.
Faulty Chip
The key fob on your Nissan Juke contains a special chip that sends a message to the vehicle every time you turn it. If the chip is damaged, it can cause the key to stop functioning. If this happens the issue is only solved by replacing the key. There are many reasons your Nissan Juke's key could be damaged, including water damage or a dead coin battery, or a broken receiver module.
If your key fob stopped working after a soak in the wash or even a bath, you must check the chip for damage from water. Make sure the metal clips that hold it in place are secure and that the chip is not exposed to any water. If you observe any signs of water damage to the electronic component, take off the battery and wipe it down with isopropyl-ethanol or electronic cleaner.
If the chip is not working If the chip is damaged, you'll have to contact your local locksmith or dealer. To locate a replacement, they will need the year, make and model of your car. Also, you will need to write down the VIN (Vehicle Identification Number) to ensure that the locksmith or dealer knows exactly which key you own. This will allow them to search for the correct key code and make sure that they are cutting the correct one.
Faulty Receiver Module
The key fob sends radio frequency signals to your car that performs various functions. It can unlock your trunk as you hurry to get groceries or start your car by pressing the button on the fob. It can also open your windows and turn on the horn in case you accidentally lock your keys in the car.
If the key fob doesn't work, it may be due to a glitch in the receiver module. The receiver modules are tuned to ensure that they can receive specific frequencies that correspond to signals transmitted by Nissan key fobs. A faulty receiver module will stop your car from responding to the signal transmitted by the key fob from Nissan.
It's a good idea to have a spare Nissan key fob in the event that your original key gets lost or breaks. A locksmith or dealership can program the spare key to work with your Nissan. This will save you from the hassles of losing your keys or locking them in your car.
If your Nissan Juke key fob has been exposed clean water from the tap or rain it is possible to have the issue cleaned with isopropyl alcohol or electronic cleaner. If, however, the chip is fried it will be necessary purchase a new key fob that is programmed to your car through a locksmith or dealer.
![[PukiWiki]](image/pukiwiki.png "[PukiWiki]")
