Peugeot 308 Key Fob Replacement

Peugeot's 308 might seem slightly old, but it is still appealing. It might not be the most luxurious car in its class and an Ford Focus or Volkswagen Golf will shield you from road imperfections, but it's a relaxing and comfortable drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following suggestions will aid in solving the issue whether it is ongoing or intermittent.

Water Damage

If you accidentally drop your key fob into a puddle, or if it is soaked while kayaking, canoeing or rafting or canyoning it is likely to be damaged by water. The best way to avoid this from happening is to keep it in a dry container when you're outdoors or performing activities where the fob could be exposed to excessive amounts of water.

img width="444" src="https://www.thekeylab.co.uk/wp-content/uploads/2022/07/IMG-2077-e1658747318588-1024x823.jpg">

You should also make sure that the fob is completely dry prior to opening it and using it again. If you detect any odors from the fob (such as industrial fluid or windshield washer fluid), this is another indication that it's been submerged.

A wet circuit could cause the battery's power to be depleted or even explode. If you're able, if you can, pull your key fob 308 out of the water in which it was stuck in it, flip the button side down and shake out as much water as possible before opening the case. After you open it, take off the battery and wipe the circuit board using the help of a cotton swab that has been dipped in 90 percent isopropyl alcohol. https://www.thekeylab.co.uk/peugeot-car-keys/ that your Peugeot 308 remote entry keyless system may not work include a dead coin cell battery or receiver module issue signal interference or a malfunctioning chip. If none of the above is the problem, you can reset the system by disconnecting a 12 volt battery from your car for 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with a remote-start feature that allows the driver to start the car from a distance and then warm up or cool down the vehicle prior to getting in. This feature is extremely helpful particularly during the cold winter months. The remote start system may be stopped for a variety of reasons, including the dead battery in the coin-battery.

A coin-shaped battery that is found inside the key fob can last for a period of between two and four years, based on how often it is used and where it is purchased. The date of use will be printed on the packaging or marked in the user manual.

If the key fob stopped functioning after being exposed to clean tapwater, remove the battery and clean the electronic chip with a paper towel soaked in isopropyl ethanol. Then dry the chip completely before replacing it. If the key fob was exposed to soapy or salty water, it may have caused the chip to be damaged. You will need to replace it.

If you're not certain the battery is in good condition it is possible to test the voltage with a multimeter set to your car's voltage range, and connect it to the minus and plus terminals. If the voltage is lower than 12-13 volts, then you must replace the battery. You can also reset your onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should start.

Faulty Receiver Module

If you're unable to see the "Key Detected" message on your dashboard, then it's possible that the receiver module has been afflicted with a fault. It's the part that transmits an alert when your key fob turns on. It also functions as an alarm that stops the vehicle from starting without the correct key.

This could be caused by several reasons, such as water damage or just getting old. If the chip inside your Peugeot 308 keyfob has been damaged by dirty tap water, it could be because the keyfob was exposed to it. In this case you'll need to remove the device apart and clean it thoroughly with isopropyl alcohol or an electronic cleaner. Once it's dry you can put the battery back in and try again.

If the issue isn't resolved the issue persists, it's a good idea to see a local Peugeot specialist or locksmith. They'll be able to make use of a diagnostic device to assist in identifying the problem and fix it.

It can be stressful to lose your Peugeot car key. However, a qualified auto locksmith can address the problem in minutes. They can program your vehicle and cut a new, working key for you. Click here to locate a locksmith near you.

Faulty Electronic Chip

The electronic chip inside the Peugeot 308 key fob plays a crucial part in the remote control system. If it becomes damaged, your car might not start, or you could receive a message that reads "anti-theft active". In this scenario, the only solution is to replace the key. Fortunately, professional auto locksmiths can offer the service in the shortest amount of time.

The chip in your Peugeot 308 key fob can fail due to water damage, sweat dirt, or any other cause. If your Peugeot 308 key fob has been exposed to soapy water, clean it right away. You can make use of a paper towel and isopropyl alcohol for cleaning the electronic component. The battery should be allowed to completely dry.

Sometimes the key fob may not function due to radio interference. This could be caused by other devices operating on the same frequency as your Peugeot key fob. It can also be caused by weather conditions or objects in the vicinity of the vehicle. If you experience this problem it is recommended to visit a Peugeot dealership.

The Peugeot 207/308 key fob is very delicate and requires care. It is imperative not to drop or throw the key fob. If you lose it, try to find it as quickly as possible. You can reset the onboard computer by disconnection of the battery for a few minutes. Make sure you disconnect the negative first, and then the positive.


トップ   編集 凍結 差分 バックアップ 添付 複製 名前変更 リロード   新規 一覧 単語検索 最終更新   ヘルプ   最終更新のRSS
Last-modified: 2024-04-25 (木) 00:41:51 (11d)