Peugeot 308 Key Fob Replacement
Peugeot's 308 might seem a bit old however it's still appealing. It's not the most luxurious car in its class and it's a Ford Focus or Volkswagen Golf will help you stay away from imperfections on the road - but it's still a pleasant and civilised driving experience.
We are often asked at Coded Car Keys to replace peugeot key fobs. The following suggestions will assist whether the issue is constant or intermittent.
Water Damage
If you accidentally drop your key fob in a puddle, or if it is wet while kayaking, canoeing, rafting or canyoning the fob is more likely to be damaged by water. Keep your key fob in a dry bag every time you are outside or perform things that expose it to large amounts of water.
You'll also need to ensure that the fob is completely dry before opening it up and using it again. If you notice any odors coming from the fob, like an industrial-like liquid smell or windshield washer fluid, it's another indication that it's been submerged in water.
A circuit board that's damp can cause the battery to dump its charge or even explode. If you're able to fish the 308 key fob of whatever body of water it was stuck in it, flip the button side down and shake out as much water as possible before opening the case. After you open it, remove the battery and wipe the circuit board using an alcohol-soaked cotton swab. 90 percent isopropyl alcohol.
Other reasons your Peugeot 308 remote entry keyless system might not function could be due to a dead coin-cell battery or receiver module issue, signal interference or a malfunctioning chip. If none of these are the cause you can reset the system by disconnecting 12 volt battery from your car for 15 mins.
Dead Coin Battery
Peugeot cars come with a remote start system that lets drivers start their vehicle from a distance, allowing them to warm up or cool down the vehicle before they get in. This feature is extremely useful especially during the cold winter months. However, sometimes the remote start system stops operating due to a range of reasons, like a dead coin battery.
A coin-shaped battery located inside the key fob can last for a period of between two and four years, based on how often utilized and where it was purchased. The date of use is usually written on the package or listed in the instruction manual.
If the key fob stops working after exposure to pure tapwater, you need to remove the battery and clean the electronic chip with an absorbent paper towel that has been soaked in isopropyl ethanol. Then, dry the chip thoroughly before replacing it. If you expose it to salty or soapy water, the chip might be fried and you will need to replace the key fob altogether.
img width="492" src="
">
If you're unsure if the battery is defective You can test its voltage using a multimeter that is set to the car's voltage range and connected to the terminals for minus and plus. The voltage should be around 12-13 volts however, if it reads lower, then the battery needs to be replaced. Alternately, you could attempt to reset the onboard computer by disconnecting the 12 volt battery for a few minutes, and reconnecting it in reverse order (positive cable first, then negative). The engine should then start after this.
Faulty Receiver Module
If you don't get the "Key Detected", it could be that your receiver module is not working properly. It's the part that sends an alert to the car when your key fob is activated which acts as an immobiliser. It also stops it from starting until the correct key is in place.
It could be due to several causes, such as water damage or just the aging process. If the electronic chip within your Peugeot 308 keyfob has been damaged due to dirty tap water it could be because the keyfob was exposed to it. In this scenario it is necessary to take the unit apart and thoroughly clean it with isopropyl alcohol, or electronic cleaner. Once https://www.thekeylab.co.uk/peugeot-car-keys/ can put the battery back in and try again.
If the issue continues to persist you're probably in need of a idea to seek out an area Peugeot specialist or locksmith. They can utilize an instrument for diagnosing to pinpoint the problem and fix it.
The loss of your Peugeot keys to your car is a stressful experience. A reputable auto locksmith can resolve the issue within minutes. They can cut a brand new key and program it to your vehicle, so you're ready to get off the road in the shortest time possible. Click here to find a local locksmith near you.
Faulty Electronic Chip
The electronic chip that is in the Peugeot 308 key fob is an vital component of the remote control system. If the chip is damaged, you may have problems starting your car or receive a message saying "anti-theft". In this scenario, the only solution is to replace the key. Fortunately, professional auto locksmiths can provide the service in the shortest time.
The chip inside your Peugeot 308's key fob could be damaged due to many reasons, including sweat, water damage or dirt. If your Peugeot key fob has been exposed soapy or dirty water, it must be cleaned right away. You can wipe the electronic component using the help of a towel that is soaked in isopropyl Alcohol. The battery must then be allowed to fully dry.
Sometimes keys may be inoperable due to radio interference. This can happen when other devices operate on the same frequency as your Peugeot keyfob. This can be caused by problems with the environment or objects near to the vehicle. It is recommended that you visit a Peugeot dealer if you experience this issue.
The Peugeot key fob 207/308 is extremely delicate and requires a lot of attention. It is imperative not to throw or drop the key fob. If you lose something, try to locate it as soon as you can. You can reset the on-board computer by disconnecting the battery for a few minutes. Make sure you disconnect the negative cable first, and then the positive.
![[PukiWiki]](image/pukiwiki.png "[PukiWiki]")
