Fiat 500 Replacement Key Fob
It could be time to replace the battery if the 500 remote key fob isn't working. If you replace the battery, but it still doesn't work, the problem may be elsewhere.
United Locksmith specializes in the creation of new keys for classic automobiles. We have the tools and parts needed for this service.
Dead Coin Battery
A dead battery is the primary reason for your Fiat 500 keyfob not locking or unlocking the doors. The battery of the coin cell inside the key fob will deplete quickly if you don't use it often enough. If your remote has started to show signs of loss of range or stopped functioning or not responding, then the battery could be dead.
The battery in the key fob is held in place by metal clips that retain it. If the clips aren't tight, they can create problems with the contact, which can stop your remote from receiving power. By using a small flathead screwdriver, pull the retaining clip open to take out the battery, and replace it with a brand new one. Choose a battery that is the same voltage, size and specifications as the original.
The key fob could be damaged or corroded by water exposure. Even a quick bath in soapy, warm water can cause damage to the chip. Make sure your key fob is dry.
Water Damage
If your key fob isn't operating properly, it may be caused by water damage. The rubber seals on key fobs stop them from being damaged by a slight drizzle or splash of water. However, it is important to keep the keys out of the washing machine, ocean, and pool.
https://www.g28carkeys.co.uk/fiat-car-key-replacements-near-me/ contains an electronic chip that sends a signal to your car's immobilizer system. The chip allows the 500 to be locked and started. If it gets wet, it will no longer work.
Try cleaning the internal electronics of your key fob with isopropyl Alcohol or an electronic cleaner to see whether they're still in good condition. However, it is probably recommended to purchase a replacement from a dealership instead of trying to fix an item that has been submerged by salt water.
While a replacement fob can cost a little money, it's far less expensive than paying for your Fiat 500 to be towed to a dealership and fixed! In addition, you can do it yourself with the simplest of steps. Make sure you have the correct type of battery before you attempt to open your key fob. You can find step-bystep directions for any key fob in your car online.
Faulty Chip
The chip located within the key fob communicates with the car's immobiliser unit to make sure your car is only able to start when the correct key is used. If the chip is damaged or damaged in any way it will not start.
img width="311" src="
">
Water damage or a dead cell battery are the most frequent causes of a faulty chip. It is best to leave the job to a professional locksmith, who can repair the chip quickly and at reasonable cost.
If your key fob fails to function after exposure to clean water from the tap or rain, take out the battery and clean the electronic component with a paper towel to ensure it is fully dry before putting it back into. If the key fob does not work, it is likely an issue with the chip and is required to be replaced.
Some people will turn to their dealer when they are in need of an entirely new Fiat key fob, but this could be a expensive option. If you're looking for a cost-effective way to have your Fiat key fob repaired, look no further than United Locksmith. We have the tools and knowledge required to fix your Fiat fob in a timely and professional manner.
Faulty Receiver Module
Fiat key fobs transmit signals of up to 50 feet to the vehicle, which will open and close the doors (and start the vehicle in case of automatic transmissions). However, there are a few factors that could cause the fob to stop working. These include a dead coin battery, water damage buttons, worn ones or a problem with the receiver module and signal interference, or an electronic chip that has failed.
If the fob has been in a pocket that has been subject to extreme trauma, like being dropped on hard floor or getting washed in a wash machine, it may not be capable of communicating with the car's Body Control Module (BCM). This is because the BCM is an extremely secure system that will only accept signals from a genuine key and not another.
You'll need to replace the fob if this occurs. A professional locksmith will handle the entire replacement process including programming a new key for your 500. They can even offer an identical fob that functions just like the original (and costs only less than the cost).
![[PukiWiki]](image/pukiwiki.png "[PukiWiki]")
