Peugeot 308 Key Fob Replacement
Peugeot's 308 might be somewhat old-fashioned but it's appealing. It's not the most luxurious car in its class, but it's a pleasant and peaceful drive.
We often receive requests from Coded Car Keys to replace peugeot key fobs. The following suggestions will aid whether the issue is persistent or intermittent.
img width="306" src="
">
Water Damage
If you accidentally drop your fob in the midst of a puddle or splash it with water during kayaking, swimming, canoeing, rafting, or canyoning, it's most likely to sustain water damage. Keep your key fob in a dry container whenever you go outdoors or do activities that expose it to a lot of water.
You'll also need to make sure that the fob is dry prior to opening it and reusing it. If you notice any smells from the fob (such as industrial liquid or windshield washer fluid) It's another indication that it's been submerged.
A wet circuit could cause the battery's charge to be drained or even explode. If you are able to get your keyfob 308 from the water, turn the button side up and shake as much water as possible before opening the casing. Take the battery out, and then wipe the circuit board down with a cotton swab that has been dipped into 90-percent alcohol.
Other reasons why your Peugeot 308 remote entry keyless system may not work include a dead battery in the coin-cell or receiver module issues, signal interference or a defective chip. If none of these are the reason it is possible to reset the system by disconnecting 12 volt battery from the car for 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with a remote-start feature that allows the driver to start the car from a distance and then warm up or cool down the car prior to entering. This feature is extremely useful, especially during winter's cold and chilly months. The remote start system may not function due to a variety of reasons, such as the battery being dead.
A coin-shaped battery located inside the key fob will last a time of two to four years, based on how often it's used and the location where it was purchased. The date of use is usually printed on the package or in the manual.
If the key fob stops working after exposure to clean tapwater, take out the battery and clean the electronic chip with a paper towel soaked in isopropyl ethanol. Then dry the chip thoroughly before replacing it. If the key fob was exposed to soapy or salty water, it may have caused the chip to become damaged. It is necessary to replace it.
If you are not sure that the battery is not working properly, you can test its voltage using a multimeter that is set to the vehicle's voltage range and connected to the minus and plus terminals. The voltage should range from 12 to 13 volts, but if it's lower, then the battery needs to be replaced. You can also reset the computer that is onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should start after this.
Faulty Receiver Module
If you're not getting the "Key Detected" message on your dashboard, then it's possible the receiver module has been afflicted with a fault. It's the component that sends out a signal when your key fob goes off. It also functions as an alarm that stops the car from starting without the correct key.
The cause could be a number of factors, including water damage or just aging. If the electronic chip inside your Peugeot 308 keyfob is damaged due to dirty tap water it could be due to the fact that the keyfob was exposed to it. In this case it is necessary to take the unit apart and clean it thoroughly with isopropyl alcohol or an electronic cleaner. When the battery is clean you can try it again.
If the issue is not resolved, it is recommended that you visit a local Peugeot expert or locksmith. They'll employ a diagnostic tool assist in identifying the problem and repair it for you.
It can be stressful to lose your Peugeot car key. A professional auto locksmith will be able to solve the issue in minutes. https://www.thekeylab.co.uk/peugeot-car-keys/ can program your vehicle and cut a brand new, working key for you. Click here to find the nearest locksmith.
Faulty electronic chip
The electronic chip inside your Peugeot 308 key fob is a very crucial component of the remote control system. If it gets damaged, your car may not start or you may get a message saying "anti-theft active". If this occurs, the only option to fix the issue is to get a new key. Auto locksmiths with experience are able to provide the fastest possible time.
The chip inside your Peugeot 308's key fob could fail due to a variety of reasons, including sweat, water damage or dirt. If your Peugeot 308 key fob has been exposed to soapy water, cleanse it immediately. You can employ a paper towel as well as isopropyl alcohol to clean the electronic component. The battery must then be allowed to dry completely.
Sometimes keys may not function due to radio interference. This could be caused by other devices operating on the same frequency as your Peugeot key fob. This can be caused by unsafe conditions or objects that are near to the vehicle. If you experience this issue it is recommended to visit an Peugeot dealership.
The Peugeot Key Fob 207/308 is fragile and requires particular care. You shouldn't drop it or throw it around. If you lose it, try to locate it as quickly as you can. You can reset the on-board computer by disconnection of the battery for a few minutes. Disconnect the negative cable before the positive.
![[PukiWiki]](image/pukiwiki.png "[PukiWiki]")
