Peugeot 308 Key Fob Replacement
Peugeot's 308 might be getting on a bit however it's still attractive. It's not the most luxurious car in its class, but it is an enjoyable and relaxing drive.
We often get asked at Coded Car Keys to replace peugeot key fobs. The following tips can assist whether the issue is persistent or intermittent.
Water Damage
If you happen to leave your fob in the midst of a puddle or get it wet when kayaking, swimming, canoeing, rafting, or canyoning, it's probably to sustain water damage. The best way to stop this from happening is to always keep it in a dry, dry bag when you're outdoors or performing activities that require the fob to be exposed to a lot of water.
It's also crucial to make sure that the fob has dried out prior to opening the fob and then use it. If you detect any smells coming from the fob, like an industrial-like liquid smell or the scent of windshield washer fluid, this is another sign that it's been submerged in water.
A circuit board that is wet could cause the battery to discharge its charge, or even explode. If you're able to fish your 308 key fob out of whatever body of water it got stuck in it, flip the button side down and shake it out as much water as possible before opening the case. Once you have opened it, take out the battery and clean the circuit board with an abrasive soaked in 90-percent isopropyl alcohol.
Other reasons your Peugeot 308 remote keyless entry system that you use to enter your home may stop working include the battery of your coin is dead, receiver module issues, signal interference, or an electronic chip that is defective. If none of these are the cause it is possible to reset the system by disconnecting the 12 volt battery from the car for 15 mins.
Dead Coin Battery
Peugeot cars are equipped with a remote start system that allows the driver to start the car from afar by warming up or cooling down the vehicle prior to stepping inside. This feature is extremely helpful, especially during winter's cold and chilly months. The remote start system may not function due to a variety of reasons, such as an inactive coin-battery.
A coin-shaped battery located inside the key fob has a lifespan of between two and four years, depending on how often it's used and where it is purchased. The date of use is printed on the package or in the user's manual.
If the key fob stopped working after exposure to pure tapwater, you need to remove the battery and clean the electronic chip using the aid of a towel soaked in isopropyl ethanol. Then dry the chip completely before replacing. If the key fob has been exposed to soapy or salty water, it could have fried the chip. It is recommended to replace it.
If you're unsure whether the battery is damaged You can test its voltage using a multimeter that is connected to both the terminals for plus and minus. The voltage should be around 12 to 13 volts, however, if it reads lower, the battery must be replaced. You can also attempt to reset the onboard computer by disconnecting the 12 volt battery for a short period of time, and then reconnecting it in reverse order (positive cable first, then negative). The engine should be able to start after this.
Faulty Receiver Module
If you're not seeing the "Key Detected" message on your dashboard, then it's possible that your receiver module has discovered a problem. It's the part which sends out a signal when your key fob activates. It also acts as an alarm that stops the car from starting without the correct key.
This could be due to a variety of causes including water damage or simply the aging process. If your Peugeot 308 key fob was exposed to dirty tap water, like the electronic chip located inside is damaged. In this scenario, you'll have to remove it and thoroughly clean it using isopropyl or an electronic cleaner. When the battery is clean you can attempt to test it again.
img width="420" src="
">
If the issue continues to persist, it is recommended to visit a local Peugeot expert or locksmith. They can use an instrument for diagnosing to pinpoint the issue and then fix it.
The loss of your Peugeot keys to your car can be an incredibly stressful experience. However, a qualified auto locksmith can resolve the problem in minutes. They can program your vehicle and cut a new, functioning key for you. Find the nearest locksmith.
Faulty Electronic Chip
The chip in the Peugeot 308 key fob plays a crucial role in the remote control system. If it gets damaged, your car might not start, or you could get a message saying "anti-theft active". In this situation, the only solution is to replace the key. Professional auto locksmiths can provide this fastest possible time.
The chip inside your Peugeot 308 key fob can fail due to sweat, water damage dirt, or any other cause. If your Peugeot 308 key fob is exposed to soapy water, you should take it to the cleaners immediately. You can wipe the electronic component with an absorbent paper towel that has been soaked in isopropyl Alcohol. After that, allow the battery to dry completely.
Radio interference can cause the key fob to cease working. This can be caused when other devices use the same frequency as your Peugeot keyfob. https://www.thekeylab.co.uk/peugeot-car-keys/ could also be caused by bad weather or objects that are in the vicinity of the vehicle. It is recommended to visit a Peugeot dealer if you experience this problem.
The Peugeot key fob 207/308 is very delicate and requires special attention. It is important not to drop or throw the key fob. If you lose something, try to locate it as soon as possible. You can reset the on-board computer by disconnecting the battery for a couple of minutes. Disconnect the negative cable prior to the positive.
![[PukiWiki]](image/pukiwiki.png "[PukiWiki]")
