Peugeot 308 Key Fob Replacement
Peugeot's 308 might seem slightly old however it's still striking. It's not the most luxurious car in its class, but it's an enjoyable and relaxing driving experience.
We often get asked at Coded Car Keys to replace peugeot key fobs. If the issue is intermittent or constant the following suggestions should aid.
Water Damage
If you accidentally drop your key fob in a puddle, or if it is soaked while kayaking, canoeing, rafting or canyoning the fob is more likely to be damaged by water. The best way to avoid this from happening is to always keep it in a dry, dry bag when you're going outdoors or doing activities that require the fob to be exposed to excessive amounts of water.
You should also make sure that the fob is completely dry before opening it up and using it again. If you notice any smells from the fob (such as industrial liquid or windshield washer fluid) it is a indication that it's been submerged.
A wet circuit can cause the battery's power to be depleted or even explode. If you're able to pull your 308 key fob out of the water body it got stuck in then flip the button side down and shake out as much water as you can before opening the case. After opening it, take out the battery and wipe the circuit board using an alcohol-soaked cotton swab. 90 percent isopropyl alcohol.
Other reasons why your Peugeot 308 remote keyless entry system might not function include a dead coin battery, receiver module issues signal interference, an electronic chip that is defective. If none of these causes the issue, try resetting your system by disconnecting the battery with 12 volts for about 15 minutes.
Dead Coin Battery
Peugeot cars come with remote start that allows drivers to start their vehicle from a distance, allowing them to warm up or cool down the vehicle before they get in. This feature is extremely useful particularly in cold winter months. However, sometimes the remote start system stops working due to a variety of reasons, like the battery of a coin that is dead.
A coin-shaped battery that is located inside the key fob has a life span of two to four years, based on how often used and where it's purchased. Its use-by date is typically printed on the package or in the manual.
img width="319" src="
">
If the key fob stops working after exposure to clean tap water, you should remove the battery, then clean the electronic chip using a paper towel and isopropyl alcohol, and then dry it completely before replacing it. If the key fob was exposed to soapy or salty water, it could have caused the chip to become damaged. It is recommended to replace it.
If you're not sure the battery is defective you can check its voltage using a multimeter set to your car's voltage range, and connect it to the minus and plus terminals. If the voltage is less than 12-13 volts you must replace the battery. Alternately, you could attempt to reset the onboard computer by disconnecting the battery at 12 volts for a few minutes, and then reconnecting it in reverse order (positive cable first, then negative). The engine should then start after this.
Faulty Receiver Module
If you don't get the "Key Detected" you might find that your receiver module is malfunctioning. It is the part which sends out an alert when the key fob goes off. It also acts as an alarm that stops the car from starting if it doesn't have the correct key.
This could be due to a number of causes including water damage or simply aging. If the electronic chip inside your Peugeot 308 keyfob is damaged due to dirty tap water it could be due to the fact that the keyfob was exposed to it. In this instance, you'll need to take it out and clean it thoroughly using isopropyl or an electronic cleaner. Once it's dry you can put the battery back in and try it again.
If the problem persists you're probably in need of a idea to visit an area Peugeot specialist or locksmith. They can utilize the diagnostic tool to pinpoint the problem and repair it.
The loss of your Peugeot keys to your car is an extremely stressful experience. However, a reputable auto locksmith can address the issue in just a few minutes. They can cut a new key and programme it to your vehicle, ensuring that you're ready to get to the road as quickly as possible. Click here to find a locksmith near you.
Electronic chip malfunctions
The chip in the Peugeot 308 key fob plays a vital function in the remote control system. If the chip is damaged, you could have problems starting your car or get a message saying "anti-theft". In this case, the only solution is to replace the key. Luckily, https://www.thekeylab.co.uk/peugeot-car-keys/ can complete the task within the shortest period of time.
The chip inside the key fob of your Peugeot 308 may fail due to various reasons, such as water damage, sweat or dirt. If your Peugeot 308 key fob has been exposed to soapy water, clean it right away. You can wipe the electronic component with the help of a towel that is soaked in isopropyl Alcohol. The battery should be allowed to fully dry.
Radio interference can cause the key fob to cease working. This could be caused by other devices operating on the same frequency as your Peugeot key fob. It could be caused by poor conditions or objects close to the vehicle. It is recommended that you visit a Peugeot dealer if you have this problem.
The Peugeot 207/308 Key Fob is delicate and requires particular care. You shouldn't drop it or throw it around. If you lose something, try to locate it as quickly as you can. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a few minutes. Remove the negative cable before the positive.
![[PukiWiki]](image/pukiwiki.png "[PukiWiki]")
