Fiat 500 Key Fob Replacement
img width="310" src="
">
If your 500 key fob doesn't work Try using a different one to see if the car will detect it. If it does, then the issue is likely to be related to the original fob's battery or water damage.
Replace the battery first. The "+" side should be facing down.
Dead Battery
The majority of the time, when a fob won't work, it's because the battery is dying. It's easy to fix and the majority of fobs will notify you that the battery is low. There are instructions on YouTube? for almost every key fob for your car, or in the owner's manual. You can also change it by taking it to an authorized locksmith or a dealer who sold it to you.
Other times, a device can not function and there could be a problem with the internal circuit board. It's not common however it can happen. The internal chip could be damaged when you drop the fob on something hard. It could be a problem if you have an aftermarket fob, and the key doesn't work. In this scenario, it is necessary to go to a dealer or locksmith to have the key reprogRammed to work with your 500.
One 2012 FIAT 500 Flip Key Remote - resembles Ilco brand with trunk, lock and lock buttons. It is a replacement keyless entry remote (will require cutting & programmed by locksmith)
Damaged Chip
A fiat 500 key fob is wireless device that gives the signal to the car to start when you push the button. It has a microchip that has information about the code required to communicate with the car. If the chip is damaged, it won't transmit the correct code, and the car won't start. Locksmiths can repair the damage. United Locksmith can complete this repair on both classic and modern models, so don't hesitate to call.
You can purchase a brand new fob and have it programmed professionally by a locksmith. This is much less expensive than going to a dealer and will function similarly. You'll need some information for the locksmith, like the year that your car was built and the model.
Rub the chip with an old dollar bill if not certain of what to do. The copper in the bill is abrasive enough take away oxidation and dirt but won't cause any harm to the microchip. If the chip is physically damaged however, it may not be capable of being repaired. This can happen when you drop the chip or run it over by your vehicle.
Water Damage
Whether you accidentally dropped your keys in the water, put them in your pocket while you were swimming at the beach, or splashed them with water on a rainy afternoon It's likely that your fob will have some water damage. Even if it's just the smallest amount of water on the key, it could cause serious problems with its electronics.
It is possible to solve this problem by removing the fob and cleaning it using a paper towel. When the fob is dry, you can then replace its battery and it should begin working properly.
You can also take your key fob to a local locksmith or auto shop to get it professionally cleaned and programmed. They can employ special equipment to make sure that the key fob functions with the computer in your car.
When your Fiat 500's key fob isn't working, it can be a stressful and frustrating. It can be expensive and difficult to transport your key fob to a dealer. A locksmith can replace your key fob with no need to visit the dealership. For this reason, they are a far better choice than an auto dealer.
Pairing Issues
If you lose your key fob, or it stops working and nothing else seems to be going on It could be due to the chip that is malfunctioning. It could be because of water damage or a dead battery.
Most of the time, this can be accomplished by following the directions in the owner's manual. If you're having difficulty or your manual doesn't work, you should have an automotive locksmith complete this task. This will ensure that the chip isn't fried, and it's also the cheapest alternative.
500 owners have reported that their key fobs will not lock their cars. https://www.g28carkeys.co.uk/fiat-car-key-replacements-near-me/ can be a problem when you want to fill up at a gas station. Some owners have reported that their 500's locking system malfunctioned and they've had to replace the entire intermediate steering shaft. Fiat has actually addressed this problem in an technical bulletin (TSB).
A reputable locksmith can help you when your Fiat is experiencing issues. They will duplicate your current key or create a new one that locks and starts the car. They can do this without having access to your old key, and is usually cheaper than buying one from the dealer.
![[PukiWiki]](image/pukiwiki.png "[PukiWiki]")
