Peugeot 308 Key Fob Replacement
Peugeot's 308 may be catching on a bit however, it's still attractive. It's not the most luxurious vehicle in its class, but it is an enjoyable and comfortable driving experience.
We are often asked at Coded Car Keys to replace peugeot key fobs. The following suggestions will assist whether the issue is ongoing or intermittent.
Water Damage
If you happen to leave your fob in a puddle or get it wet while swimming, kayaking, canoeing, rafting or canyoning, it's most likely to suffer water damage. Keep your key fob in a dry bag every time you go outdoors or do activities that expose it to excessive water.
It's also crucial to ensure sure that the fob has dried out prior to opening it and use it again. If you notice any smells from the fob (such as industrial fluid or windshield washer fluid) it is a sign that it has been submerged.
A wet circuit could cause the battery's charge to drain or even explode. If you're able to fish your 308 key fob out of whatever body of water it was stuck in, flip the button side down and shake out as much water as possible before opening the case. Take the battery out, and then wipe the circuit board clean using a cotton swab which has been submerged in 90 percent alcohol.
Other reasons that your Peugeot 308 remote entry keyless system may not work include a dead coin-cell battery or receiver module malfunction, signal interference or a defective chip. If none of the above are the problem you can reset the system by disconnecting the 12 voltage battery from the car for 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with a remote-start system which allows the driver to start the car from afar and then warm up or cool down the vehicle prior to stepping inside. This feature is extremely beneficial, especially during cold winter months. However, sometimes the remote start system ceases operating due to a range of reasons, like the battery of a coin that is dead.
A coin-shaped battery located inside the key fob will last a time of between two and four years, based on how often used and the location where it was purchased. The date for use-by is typically printed on the packaging or marked in the manual.
If the key fob stops working after exposure to water that is clean then you must remove the battery, clean the electronic chip using a paper towel and isopropyl alcohol, and then dry it thoroughly before replacing it. If the key fob was exposed to salty or soapy water, it could have caused the chip to become damaged. It is necessary to replace it.
If you're unsure whether the battery is defective you can check its voltage with a multimeter that is connected to both the terminals for plus and minus. If the voltage is less than 12-13 volts you should replace the battery. Alternatively, you can try to reset the onboard computer by disconnecting the battery at 12 volts for a short period of time, and then reconnecting it in reverse order (positive cable first and then negative). The engine should start after this.
Faulty Receiver Module
If you don't get the "Key Detected" It could be the receiver module not working properly. It's the component that transmits a signal when your key fob turns on. It also acts as an alarm, and stops the car from starting if you don't have the correct key.
This can be due to several factors, including water damage or just getting old. If your Peugeot 308 key fob has been exposed dirty tap water, for instance, the electronic chip inside the device will be damaged. In this situation, you'll need to remove it and clean it thoroughly using isopropyl or electronic cleaner. Once it's dry you can put the battery back into the battery and try again.
If the issue continues to persist then it's a good option to consult an area Peugeot specialist or locksmith. They'll be able to make use of a diagnostic device to identify the problem and fix it.
The loss of your Peugeot car keys can be an extremely stressful experience. However, a trained auto locksmith can address the issue in just a few minutes. They can program your car and cut a brand new, working key for you. Click here to locate locksmiths near you.
Faulty electronic chip
The electronic chip inside your Peugeot 308 key fob is a very important component of the remote control system. If the chip is damaged, you may have problems starting your car or get a message saying "anti-theft". If this occurs, the only solution to fix the problem is to get a new key. Auto locksmiths with experience are able to provide the service in the shortest time.
The chip in your Peugeot 308 key fob can fail due to water damage, sweat dirt, or any other cause. If your Peugeot 308 key fob has been exposed to soapy water, it is recommended to clean it right away. You can make use of a towel and isopropyl alcohol to clean the electronic component. Then, you need to allow the battery to completely dry.
Sometimes the key fob may be inoperable due to radio interference. This could be caused by other devices that operate at the same frequency as your Peugeot key fob. It could be caused by bad conditions or objects close to the vehicle. https://www.thekeylab.co.uk/peugeot-car-keys/ is recommended to visit a Peugeot dealer if you experience this problem.
The Peugeot Key Fob 207/308 is fragile and requires special attention. You should not drop it or throw it around. If you lose something, try to find it as quickly as you can. You can reset all on-board computers by disconnecting the 12 volt battery for a short period of time. Disconnect the negative cable prior to the positive.
img width="485" src="
">
![[PukiWiki]](image/pukiwiki.png "[PukiWiki]")
