Peugeot 308 Key Fob Replacement
Peugeot's 308 might be somewhat old-fashioned however it's still eye-catching. It's not the most luxurious car in its class It's an Ford Focus or Volkswagen Golf will isolate you even better from road imperfections, but it's still a pleasant and civilised driving experience.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. No matter if the issue is ongoing or continuous these tips will assist.
Water Damage
If you accidentally drop your fob in a puddle or splash it with water during kayaking, swimming, canoeing, rafting or canyoning, it's more likely to suffer water damage. Keep your key fob in a dry bag every time you go outside or engage in activities that could expose it to excessive amounts water.
It's also crucial to make sure that the fob is completely dried out before you open it to use it again. If you detect any smells emanating from the fob like an industrial-like liquid smell or the scent of windshield washer fluid, it's another indication that it's been submerged in water.
A wet circuit may cause the battery's charge to drain or even explode. If you can pull the 308 keyfob from the water and turn it upside up and shake as much water out as you can prior to opening the casing. When you've opened it, remove the battery and wipe the circuit board with an abrasive soaked in 90 percent isopropyl alcohol.
Other reasons your Peugeot 308 remote entry keyless system may not work could be due to a dead coin-cell battery, receiver module problems signal interference or a defective chip. If none of the above are the reason, you may try resetting the system by disconnecting the battery that is 12 volts for around 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote-start feature that allows the driver to start the car from afar by warming up or cooling down the vehicle prior to getting in. This feature is extremely useful, especially in the cold winter months. The remote start system can be stopped for a variety of reasons, including the battery being dead.
A coin-shaped battery found inside the key fob will last a time of two to four years, based on how often utilized and where it was purchased. Its use-by date is typically printed on the package or marked in the manual.
If the key fob stops working after exposure to water that is clean it is recommended to remove the battery, clean the electronic chip with a paper towel and isopropyl alcohol, then dry it thoroughly before replacing it. If the key fob has been exposed to salty or soapy water, it could have caused the chip to be damaged. It is necessary to replace it.
If you're unsure whether the battery is in good condition it is possible to check its voltage with a multimeter connected to both the terminals plus and minus. https://www.thekeylab.co.uk/peugeot-car-keys/ should be between 12-13 volts but if it is lower, the battery must be replaced. You can also try to reset the onboard computer by disconnecting the 12 volt battery for a few minutes, and then reconnecting it in reverse order (positive cable first and then negative). The engine should then start.
img width="455" src="
">
Faulty Receiver Module
If you don't see "Key Detected" It could be that your receiver module is faulty. It's the component which sends out a signal when your key fob is activated. It also functions as an alarm that stops the vehicle from starting without the correct key.
It could be due to several causes, such as water damage or simply ageing. If your Peugeot 308 key fob has been exposed to dirty tap water, for example, the electronic chip on the inside will be damaged. In this scenario, you'll need to take it out and thoroughly clean it with isopropyl or electronic cleaner. Once it's dry you can put the battery back in and try again.
If the issue is not resolved, it is recommended to consult an area Peugeot expert or locksmith. They will be able to use a diagnostic tool to identify the issue and repair it for you.
It can be stressful to lose your Peugeot car key. However, a reputable auto locksmith can solve the problem in minutes. They can cut a brand new key and then program it into your vehicle, so you're out on the road as quickly as possible. Click here to find a local locksmith near you.
A malfunctioning electronic chip
The electronic chip in your Peugeot 308 key fob is a very crucial component of the remote control system. If the chip is damaged, you may experience difficulties starting your vehicle or receive a message saying "anti-theft". In this instance, the only solution is to replace the key. Professional auto locksmiths are able to provide this service within the shortest possible time.
The chip inside your Peugeot 308 key fob can be damaged due to water damage, sweat dirt, or any other cause. If your Peugeot 308 key fob has been exposed to soapy water, take it to the cleaners immediately. You can make use of a towel and isopropyl alcohol for cleaning the electronic component. The battery should be allowed to dry completely.
Radio interference can cause the key fob to stop working. This can be caused by other devices operating on the same frequency as your Peugeot key fob. This can be caused by unsafe conditions or objects that are within the vicinity of the vehicle. It is recommended to see a Peugeot dealer if you experience this issue.
The Peugeot 207/308 key fob is extremely delicate and requires special attention. It is essential not to throw or drop the key fob. If you lose it, try to locate it as quickly as is possible. You can reset the on-board computer by disconnection of the battery for a couple of minutes. Be sure to disconnect the negative cable first, and then the positive.
![[PukiWiki]](image/pukiwiki.png "[PukiWiki]")
